Backside Electronics for my Ender 3
Posted by Stefan Schmidt onHe strikes again... Teaching Tech with his all in one rear mounted electronics case.
Ok almost, since I have cable chains on my printer
But hey this guy has a remix with a my cable chain connector, but not my MKS GenL 1.0 board, meeehh
Hmm after about 5 min thinking and the power of sharing (and Fusion 360) I combined them to the Ender 3 all in one, universal rear electronics case - Right Case mks gen l with dragchain connector, printed it and now I have the electronics in the trunk too
Yes this is crooked, it will be next
Trackbacks
Trackback specific URI for this entryThis link is not meant to be clicked. It contains the trackback URI for this entry. You can use this URI to send ping- & trackbacks from your own blog to this entry. To copy the link, right click and select "Copy Shortcut" in Internet Explorer or "Copy Link Location" in Mozilla.
No Trackbacks
The author does not allow comments to this entry
Comments
Display comments as Linear | ThreadedNo comments