He strikes again... Teaching Tech with his all in one rear mounted electronics case.
Ok almost, since I have cable chains on my printer :-(

But hey this guy has a remix with a my cable chain connector, but not my MKS GenL 1.0 board, meeehh :-(

Hmm after about 5 min thinking and the power of sharing (and Fusion 360) I combined them to the Ender 3 all in one, universal rear electronics case - Right Case mks gen l with dragchain connector, printed it and now I have the electronics in the trunk too ;-)


Yes this is crooked, it will be next

No comments

The author does not allow comments to this entry